Thor Hemoxian 1/100 Assembly Tips for a Clean Build

Quick Answer

To get a clean, sturdy Thor Hemoxian build, follow a step-by-step process that starts with part prep and ends with careful posing—each step has a common mistake you can avoid.

Assembly Steps for a Clean Thor Build

1. Prep Your Workspace and Runners: Lay out all runners and check the manual to identify each part. Organize parts by step number to avoid confusion. Common mistake: skipping this step leads to mixing up similar-looking parts. Checkpoint: confirm each runner matches the manual before cutting.
2. Cut Parts with a Sharp Nippers: Use a sharp pair of nippers to cut parts from the runner, leaving a small nub. Cut away from the part to avoid stress marks. Common mistake: cutting too close to the part can tear the plastic. Checkpoint: leave 1-2mm of nub, then trim later.
3. Clean Nubs with a Hobby Knife or Sanding Stick: Carefully trim the remaining nub with a hobby knife, then sand the area smooth with a fine-grit sanding stick to match the surrounding surface. Common mistake: sanding too aggressively can flatten curved surfaces. Checkpoint: use light pressure and check the surface with your fingertip.
4. Dry-Fit Before Final Assembly: Temporarily fit parts together without glue or full snap to check alignment. This is especially important for large armor pieces. Common mistake: forcing parts can cause stress marks or breakage. Checkpoint: if a joint feels tight, sand the peg slightly.
5. Assemble in Sub-Assemblies: Build the torso, arms, legs, and head separately before joining them. This makes painting and panel lining easier and reduces strain on joints. Common mistake: fully assembling before finishing details makes it hard to reach inner parts. Checkpoint: leave joints slightly loose until final assembly.
6. Pose Carefully: Once assembled, move joints gently and support heavy parts while posing. Use the included stand if available to avoid stress on the ankles. Common mistake: posing too quickly can pop joints or stress the plastic. Checkpoint: support the torso while adjusting the legs.

Kit to Consider

• Thor "The Entropy of Gods" - Hemoxian 1/100: The Thor "The Entropy of Gods" Hemoxian 1/100 kit features an imposing design inspired by mythological thunder deities and futuristic mecha aesthetics. The intricate armor and mechanical details reward careful assembly and clean nub removal to keep the surface finish crisp.